Description
The CP710 combines the high volume of centrifugal pumps with increased pressure by using the large diameter jet pump impeller. The pump can be used as an automatic water pressure system with the MassControl or a mechanical switch.
When using a pressure tank with the MassControl the pressure tank should be plumbed down fl ow from the switch. A check valve is required on the outlet of the MassControl to prevent water surging between the tank and the MassControl spring diaphragm tank. This surging between the two tanks will activate the flow sensor of the MassControl which will keep the sensor on and the pump operating. See diagram. The CP710 is not recommended on installations with long suction lines.
On a mechanical switch system a pressure tank of at least 20 litres is recommended to reduce water hammering caused when the pump reaches the cut-in pressure and a large volume of water is delivered into the discharge pipe.
Model Specification Table
| Model | Watts | Volts | Amps | IP Rating | Inlet/Outlet | Shaft Seal | Temp Fluid |
| CP710 | 1500 | 220-240V | 9.7A | IPS5 | 50/40mm | Carbon Ceramic | 65°c |
| CP710 | 1500 | 415V | 3.5A | IPS5 | 50/40mm | Carbon Ceramic | 65°c |
MassControl Features
- CP Motor
- Constant Pressure
- Loss of Prime Protection
- Easy to install swivel connector
- Plug & Play electrical lead
- Inbuilt check valve
MassControl Benefi ts
- Ideal for Farm & Irrigation
- No Maintenance or adjustments
- Run dry protection
- Anti-Cycling function
